To achieve correct color blend, always use brick from several packs.

 

Face Brick meet and exceed:

ASTM C-216, Grade SW, Type FBS

Average compression strength: 9507 PSI

Average absorption: 4.87%

 

Paving Brick meet and exceed:

ASTM C-902

Average compression strength: 11283 PSI

Average absorption: 3.8%

 

Cleaning: Do Not Use Muriatic Acid.

We recommend SureKlean or its equivalent. Always follow manufacturer’s directions. Always test cleaner on a small hidden area of the wall before using any product.

 

Notice: Manufacturer disclaims all responsibility for improper cleaning. Should brick shipment fail to meet quality and/or color standards, you should notify manufacturer immediately. Once brick are in the wall the manufacturer will not assume responsibility.

 

WARNING: The dust generated from dry sawing brick may contain     

silica and may be a potential health problem. Wet sawing                            

                          is recommended.

 

Efflorescence: As defined by the dictionary, efflorescence is a growth of salt crystals on surfaces due to evaporation of salt-laden water.

 

Since brick and brick pavers are fired only once, the brick is referred to as a bisque product. In pottery, normally you would glaze your piece and fire a second time to give color, texture and seal the piece to make it waterproof since brick at the bisque stage will absorb moisture. As the heat from the sun pulls the moisture to the surface, any salt that may be in the raw material or water will be leached to the face of the brick. As the moisture evaporates the salt crystals are left on the face of the brick or brick pavers in the form of a white discoloration or powder. When the salt is gone, the efflorescence will stop. The white powder will disappear usually on its own. To speed its disappearance, clean water and a stiff brush will generally remove it. For more difficult deposits, you may want to use a masonry cleaner such as SureKlean. Always follow the product manufacturer’s directions.